2 MAN POST HOLE DIGGER
|
Auger sizes: 12", 8" or 6" 36" long with a 1' extension available |
| 300 SERIES HOLE DIGGER | |
| MODEL | 330H, 343H and 357H Series |
| Make and Model | Honda GXV140, 4-cycle |
| Horsepower | 3600 RPM |
| Muffler | Lo Tone type |
| Starter | Hand rewind |
| Fuel | Gasoline, regular or unleaded grade |
| Spark Plug | Resistor type |
| TRANSMISSION | |
| Type | Totall-enclosed, oil-lubricated, spur gear reduction |
| Nominal Auger Rotation Speed At Rated Engine Speed | 144 |
| Auger Rotation Direction | Right hand (clockwise) into the ground |
| Clutch | All-metel, oil-cooled, automatic-centrifugal, slips (dose not fully disengage) on overload |
| Drive shaft Connection To Auger | 330H: 1 3/8" (35 mm) hexagon,
General® type 343H: 7/8" (22 mm) square, Ground Hog® type 357H: Stihl® type |
| Maximum Drilling Torque | 190 ft./lbs. (225 N.m) |
| AUGER | |
| Design | Auger construction features Pengo® type, cast-steel boring heads, forged-steel teeth and cast-steel screw bits for maximum digging performance and versatility in a wide cross section of soil compositions. Thick, cross-sectioned helicoid or sectional auger fighting delivers strength and wear resistance. Fighting pitch is set to produce cleaner, more usable holes in sandy or granular type soils. All head wear parts are field replaceable. |
| Diameter | 2" (51 mm) to 18" (457 mm) |
| Lead Auger Auger Extension Length |
A full line of lead augers and continues auger extensions designed to extend the digging depth is available in standard 36" (914 mm) effective lengths |
| GENERAL | |
| Throttle Control | Heavy-duty, spring-return, Magura® twist grip type |
| Operator Handle | Comfort-Flex™ handles are ergonomically positioned to enhance operator control, and help minimize fatigue. A high-strength composite material resists ultraviolet radiation, absorbs vibration and stress while helping to insulate against inadvertent auger contact with buried underground power sources |
| Weight | 71 lbs. (32 kg) approximate |
All specification are general in nature and are not intended for specific application purpose. General Equipment Company reserves the right to make changes in design, engineering, or specifications and to add improvements or discontinue manufacture at any time without notice or obligation. Consult the applicable operator manual and support material before utilizing the produce. Refer to OSHA 2207 and/or current revisions for specific information. Names depicted are the registered trademark of their respective owners.